Aneeb Spray 90, is a Spray based bonding agent provides excellent performance to bond gypsum plasters/ Sand Cement Plaster on smooth low suction internal RCC surfaces and it eliminate hacking roughening and putting wire mesh on concrete surface.. It is an especially formulated ready to use adhesive consist in organ resins additives and additives.
How it work
The unique high polymer based formulation is one of unique formulation in the Emulsion state which can bind the concrete and plaster of Paris together. Some of the unique properties of the bonding adhesive are listed below:-
This adhesive formulation has low wet density since it contains more Amount of high polymers than fillers. It also results in high coverage to the range of 9 sq/m.
High tensile strength of the polymer film used in the formulation:
The tensile strength of the polymer film is very high to the level of 2.35kN and thus it can bear more
hanging load. Easy to apply due to low viscosity of 60 cPs at 60 rpm With spindle number in viscometer.
How to apply:
The bonding agent should be well shaken before applying the same on well cleaned surface. The surface should be cleaned with a piece of cloth and should be tree of oil or any other organic matter. One coat of the film should be made with the help of spray. The formulation cannot be Diluted by the addition of water and the addition of any other additive is not recommended. The formulation should be stored in clean dry and sealed container. The sealed container should be Avoided from the exposure of direct sunlight.
Gypsum Plaster will be applied any time once Aneeb Spray 90 dries completely on to the surface approximate time for drying is 24 hours. (Again it would depend on the climatic conditions and location).
Approximate Coverage would be 9.0 Sq Mtr.per Kg. depends Up on background surface and its suction properties.